Through hole 50A high current bridge rectifiers KBPC5010
single-phase
Description
A diode bridge rectifier is a device for converting AC, or
alternating current electricity into DC, or direct current. AC
electricity goes from positive to negative constantly, whereas DC
always flows in the same direction. AC electricity is more
efficient to transmit and easier to convert into different
voltages, so power is transmitted from the station to your house as
AC. However, most appliances need DC current to run. A diode bridge
rectifier is the most common type of power supply used to provide
this current.
Bride rectifiers are classified into several types based on these
factors: type of supply, controlling capability, bride circuit’s
configurations, etc. Bridge rectifiers are mainly classified into
single and three phase rectifiers. Both these types are further
classified into uncontrolled, half controlled and full controlled
rectifiers.
The main advantage of this bridge circuit is that it does not
require a special centre tapped transformer, thereby reducing its
size and cost.
Features:
• Metal case for maximum heat dissipation
• Surge overload ratings-400 Amperes
• Low forward voltage drop
Mechanical data:
• Case: Metal, electrically isolated
• Epoxy: UL 94V-0 rate flame retardant
• Terminals: Plated .25"(6.35mm) Faston lugs, solderable per
MIL-STD-202E, Method 208 guaranteed
• Polarity: As marked
• Mounting position: Any
• Weight: 30 grams
Application:
It is used in many electronic devices including laptop computers,
cellular phones and PDA's. Depending on how you're viewing the
electronic component
Maximum ratings and electrical characteristics:
Rating at 25℃ ambient temperature unless otherwise specified.
Resistive or inductive load,60HZ.
For capacitive load, derate current by 20%
| Characteristics | Symbol | KBPC5010 | Unit |
| Maximum recurrent peak reverse voltage | VRRM | 1000 | V |
| Maximum RMS bridge input voltage | VRMS | 700 | V |
| Maximum DC blocking voltage | VDC | 1000 | V |
| Maximum average forward rectified output current. @Ta=55°C | I(AV) | 50.0 | A |
| Peak forward surage current 8.3ms single half sine-wave super
impossed on rated load(JEDEC method) | IFSM | 400 | A |
| Maximum instantaneous forward voltage drop per bridge element at
25A | VF | 1.1 | V |
Maximum DC reverse current @Ta=25°C at rated DC blocking voltage per element @Ta=100°C | IR | 10.0 500 | uA |
| Rating for fusing(t<8.3ms) | I2t | 664 | A2sec |
| Typical junction capacitance | Cj | 300 | pF |
| Typical thermal resistance | RθJA | 2.2 | ℃/W |
| Operating junction temperature range | TJ | -55~150 | ℃ |
| Storage temperature range | TSTG | -55~150 | ℃ |
NOTES :
1. Measured at 1 MHZ and applied reverse voltage of 4.0 volts
2. Thermal Resistance from Junction to Case per leg.
Dimension:(mm)
